background image

WARNING

Shock hazard.
Be sure AC power is not connected
before performing this procedure.

3

Place the Body Fan Mounting
Bracket behind the Body Fan
Bracket and secure with the
(2) 1/4-20 x 1/2” screws.

In this kit you should find the following parts:

SUPPORT RAILS

(under acrylic)

pg. 1

24735-02A

2

Slip the Body Fan into the Body Fan
Endcap, as shown. Be sure to insert
the wire connector into the rectangular
hole and route the wire in the groove
in the Body Fan Bracket.

Installing the Body Fan on a SUNSTAR ZX32    

(With 3 Support Rails)

Before beginning this procedure... If your bench has three support rails under the bench acrylic, read this sheet.
If your bench has four rails, read the other sheet. You will need a #2 Phillips screwdriver to perform this procedure.

(4) - #10 x 1/2” Phillips pan head
sheet metal screws

(2) - 1/4-20 x 1/2” Phillips pan head
machine screws with lock washer

Body Fan
Mounting Bracket

Body Fan

Body Fan
Endcap

1

Open the bench acrylic shield and
remove the Foot End Bench Endcap
by removing the four screws that
hold it in place. Save these screws
to install the new endcap.

Summary of Contents for ZX32

Page 1: ...in the Body Fan Bracket Installing the Body Fan on a SUNSTAR ZX32 With 3 Support Rails Before beginning this procedure If your bench has three support rails under the bench acrylic read this sheet If your bench has four rails read the other sheet You will need a 2 Phillips screwdriver to perform this procedure 4 10 x 1 2 Phillips pan head sheet metal screws 2 1 4 20 x 1 2 Phillips pan head machine...

Page 2: ...ith the 4 10 x 1 2 screws 6 Close the bench acrylic 4 Connect the Body Fan power cord to the cord coming out of the end of the bench Using the screws removed from the old endcap attach the new endcap to the bed Start all four screws in their holes before tightening Tighten the screws pg 2 24735 02A ...

Page 3: ...uld find the following parts SUPPORT RAILS under acrylic Before beginning this procedure If your bench has four support rails under the bench acrylic read this sheet If your bench has three rails read the other sheet You will need a 2 Phillips screwdriver to perform this procedure 4 10 x 1 2 Phillips pan head sheet metal screws 2 1 4 20 x 1 2 Phillips pan head machine screws with lock washer Body ...

Page 4: ...lding the Endcap and Body Fan together connect the Body Fan power cord to the cord coming out of the end of the bench Then pull the Body Fan almost out of the endcap as you put the endcap in place and drop the Body Fan into the Body Fan Mounting Bracket Using the screws removed from the old endcap loosely attach the new endcap to the bed Start all four screws in their holes only a few turns pg 4 2...

Reviews: