SunStar KM-640BL, User Manual

Page: 10 / 30

10
1) Installation of machine head
Insert the hinge rubber
①
into the table. After inserting the oil tray in the middle of head supporting rubber B
②
as shown in
the figure 1, install it into the table. Insert the machine head hinge
③
into the bed holes. By inserting it into the hinge rubber
①
, stand the machine on the head support rubber A
④
and the head support rubber B
②
.
[Figure 1]
[Figure 2]
2) Installation of power switch box
When attaching the power switch box ① , refer to Figure 2 to
make sure that it is placed at the lower right of the table.
oil tray (oil fan)
2
Installation
Warning
▶ Installation of the machine should be performed by a trained engineer.
▶ Any electrical wiring must be performed by a qualified technician or agent.
▶
The machine weighs over 43kg. At least 2 persons should carry out the installing work.
▶
Plug in after the installation is complete.
▶
If the operator mistakenly steps down on the pedal with the pug in, the machine will start
automatically and can cause physical injuries.
▶
Connect the ground (earth) wire.
▶ An unstable connection may result in an electric shock or a malfunction.
▶
Place the belt cover on top of the machine.
▶
Use both hands when bending the machine backwards or returning it to the normal position.
Using only one hand can lead to severe hand injuries due to the weight of the machine.