24
7-1-2. Supplying oil
7-1-2-1. Oil flow in gear box
[ Check the oil flow ]
·
It is standard that the oil surface is in the middle of “MAX” and
“MIN” carved lines on the oil window on the gear box cover
①
.
(Upon shipment, about 150ml lubricant is in the gear box.)
1. Check from the front the oil flow in the oil window
①
on
the gear box cover.
2. If the oil surface is lower than the “MIN” carved line, supply
oil in the following orders.
[ Supplying Oil ]
Always use genuine lubricant of SunStar.
(Lubricant is in the accessory box of the machine.)
1. Disassemble the air exhaust rubber cap
③
.
2. Pour lubricant so that oil surface is in the middle of “MAX”
and “MIN” carved lines on the oil window on the gear box
cover
①
. Be careful not to make lubricant overflow.
3. Assemble the rubber cap
③
and push it down completely.
[ Caution ]
·
Bend the machine body backward to check the oil flow
in the gear box.
·
Since the height of oil in the oil window
①
on the gear
box cover depends on the degrees at which the
machine is bent, bend the machine body backward
with the body sustaining pole installed correctly (See 4-
2 7. Machine body).
[ Caution ]
·
Make sure that lubricant is not over the “MAX” carved
line, or that can cause an oil leakage.
[ Figure 34 ]
[ Figure 35 ]
①
②
③
①
Summary of Contents for KM-2300
Page 2: ......
