28
6.4) Adjustment of the stitch length
Adjusting dial
and
designed to control the stitch
length can be set up with two different lengths, and
change the stitch length whenever switch
is pressed
down. After pressing down switch
to turn the switch
on, the sewing machine will carry out sewing at the
stitch length as set on dial
. When pressing down
switch
again to turn the switch off, the machine will
start sewing at the stitch length as set on dial
. Set the
desired stitch length to a carved sign
.
6.5) Adjustment of Presser Foot Lift
The overlap between the main presser foot
and the
sub presser foot
could be set at 1~7mm using the
climb dials
,
which adjust the presser foot lift. Place
the desired numbers of the climb dials
,
at the
punched mark
, and the main presser foot
and the
sub presser foot
overlap according to the set value. In
addition, during the sewing process when the hem
height difference is high, the lap switch
can be used.
When the lap switch is pressed, the set value at the dial
becomes the overlap value of the presser feet. When
the lap switch is pressed once again, the overlap value is
converted back into the value of the dial
.
[Fig. 6-8]
[Fig. 6-9]
The value set on the stitch length dial
should always be smaller than that of dial
. Nonetheless, if
you force turning the dial to set the value of dial
to be greater than that of dial
, the machine can
be severely damaged.
The function of the stitch length dial
is available only for trimming type machines. Stitch length dial
is installed for non-trimming types.
Caution
The value of the climb dial
should be bigger than that of the climb dial
all the time. If the dial
is
adjusted to have a lower value than the dial
, it may cause damage to the machine.
Caution
Summary of Contents for KM-1070 SERIES
Page 2: ......