7
APPENDIX B
Changing the Direction of Motor Rotation for the Sunea Motor ONLY.
The Sunea Motor can be identified by the Silver Motor with a Round Case.
Note: These instructions will erase previous Motor stops for the Open and
Closed positions, as well as allow the user to reverse direction of the Motor.
These instructions must be followed accurately and completely.
Note: Select the appropriate Channel on the MultiChannel Remote, if applicable.
1. Read these instructions FIRST, completely and thoroughly.
2. Press and Hold the my button; the red LED light should blink for at least 5 seconds.
3.
Disconnect Power for 2 full seconds.
4. Connect Power for 10 full seconds.
5. Disconnect Power for 2 full seconds.
6.
Connect Power. The Awning should move, then stop.
7. Press and hold the Programming button for ten seconds, watching for two separate jogs
back and forth, several seconds apart.
A single jog is defined as a quick two-direction movement of the motor.
8.
Press and Hold the CLOSE
and
OPEN buttons together, release when the Awning jogs.
9. Press the CLOSE button to check the direction of the motor.
The fabric should roll onto the top of the Roller Bar, closing the Awning.
10. If the direction is incorrect, change direction by Holding the my button until the motor jogs.
Press the CLOSE button again, to check for the correct direction of the motor.
Programming
Rear View
OPEN
Front View
my
CLOSE
Channel
Indicator
Lights
11. Move the Awning to the desired Closed position.
12. Press and Hold the my
and
OPEN buttons together, release when the Awning begins to OPEN
.
13. Press the my button to Stop the Awning at the desired Open setting.
14. Use the CLOSE
and
OPEN buttons to make desired adjustments to the Open position.
15. Press and Hold the my
and
CLOSE buttons simultaneously, releasing them when the Awning
begins to close. The Awning will stop on its own, at the Closed position set in step 11.
SET PROPER DIRECTION OF MOTOR ROTATION
SET THE CLOSED AND OPEN POSITIONS
PREPARE MOTOR
16. Press and Hold the my button; releasing when the Awning jogs. This step stores the Open
and
Close positions.
17. Press and Hold the Programming button, wait for jog. This completes the procedure.
18. Test the Awning for correct one-touch operation, using the Open
and
Closed buttons.
FINALIZE PROGRAMMING OF MOTOR
Silver Motor with
a Round Case
To
ADD
an
additional Control Device (second Remote, All Weather Remote or Wireless Switch).
• Press the Programming button on the back of the Transmitter that was supplied with the EasyShade
until the motor “jogs.”
• On the additional Control Device, press the Programming button until the motor “jogs,” then release
To
DELETE a Control Device, repeat the two steps listed above and the additional Control Device is removed.
To Add or Delete a Control Device (Transmitter)
Channel
Selector
Button
