932208 Rev. A
V I I I . S e t - U p , A d j u s t m e n t & U s e
33
V I I I . S e t - U p , A d j u s t m e n t & U s e
932208 Rev. A
32
2
A
B
A
B
SEATING SYSTEM SET-UP
A. SEAT PAN AND BACK SIZE ADJUSTMENTS
Your Perfect Fit seating system can be adjusted to a
wide range of widths and depths to accommodate
specific user needs. Seating dimensions should only
be altered by a trained professional and may require
new seat cushions. Please refer to the Perfect Fit
Growth Guide for more detailed instructions on how
to customize the size of your seat.
B. PRE-TILT (PACKER MODULE ONLY)
The Packer Module can be mounted with the use of
an additional mounting bracket to provide four dif-
ferent pre-tilt settings (0°, 3°, 6°, 9°). Figure 1
demonstrates three of these angles and how they
can be achieved using the mounting bracket and two
sets of screws. To achieve 0°, the Packer Module
should be bolted directly to the seat frame interface.
C. MODULE INSTALLATION
The Packer, Lift, or tilt modules can mount to the
seat frame adapter in two potential locations (A or
B) as pictured in Figure 2.
If the chair was ordered with one of the above mod-
ules, it ships standard in configuration A. the mod-
ule can be moved forward to position B to move the
center of gravity for the chair more forward.
1
3°
6°
9°
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the
receiver:
a. Loosen the four bolts on the sides of the receiv-
er.
b. With the armrest in the receiver, squeeze the
receiver to achieve the desired fit.
c. Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a. Two set screws are installed in the outer arm-
post.
b. Turn the set screws in or out until the desired fit
is achieved.
J. SEAT DEPTH
The seat depth can be adjusted in one inch increments on
standard rehab seating.
1. Seat Frame Depth Adjustment
a. To adjust, remove the two bolts (A & B) from
each side of the backrest pivot plate.
b. Reposition the backrest to the desired position.
c. Replace and retighten bolts on each side of the
backrest pivot plate.
2. Back Angle Adjustment on Seat Frame
a. Remove the front securing bolt (A) on the side
of the backrest hinge plate.
b. Loosen the lower rear bolt (B)
c. Set at desired angle. There are five holes (in 4º
increments) to choose from.
d. Reinstall the front bolt and tighten both bolts
securely.
A
B
