Sunrise Medical Breezy Relax, Directions For Use Manual

Page: 5 / 16

16
Breezy Relax/Quickie Relax
EE
NN
GG
LL
IISS
HH
0305/3/ST-000690xxx.EMS
The backrest can be swung for-
wards to enable transportation.
First remove the safety splint.
Secure the backrest so that it can-
not accidentally fall and pull the
release knob (1). Then fold the
backrest forwards.
Caution!
Risk of injury – the backrest
must be secured/held before releasing it.
To get the backrest back into the upright position,
fold the backrest up and engage the bracket.
Caution!
Risk of injury – you must make sure that the
backrest is correctly clicked into the bracket!
Wheel locks (7.10.2)
The wheelchair is equipped with
two wheel locks. The wheel locks
are applied directly against the
tyres. To engage, press both wheel
lock levers forward against the
stops (Fig. 10.1). To release the
wheel, pull the levers backwards.
Braking power will decrease with:
• Worn tyre tread
• Tyre pressure that is too low
• wet wheels
• improperly adjusted wheel locks
The wheel locks have not been designed to be used
as brakes. When moving, do not operate the wheel
locks. Always use the handrims for braking.
Make sure that the gap between the wheel locks
and the tyres complies with the given specifications
(Fig. 10.2). To readjust, loosen screw (1) and set the
appropriate gap. Tighten screw again (see the page
on torque).
CAUTION!
After each adjustment of the rear wheels, check
the brake setting and if necessary, readjust.
Handling Option - Brakes
Quick-release axles on rear
wheel
The rear wheels are fitted with a
quick-release axle. The wheels can
be removed and put back on with-
out using tools. To remove a
wheel, simply depress the quick-
release button (1) and pull the rear
wheel off.
CAUTION!
Hold the quick-release button on
the axle depressed when putting
the wheel back on. Release the button to lock
the wheel in place. The quick-release button
must spring back to its original position.
1
Options – Step Tubes
Footrest
Step Tubes (7.1)
Step tubes are used by attendants
to tip a wheelchair over an
obstacle. Simply step on the tube
to push a wheelchair, for example,
over a curb or step.
Drum brakes (7.13)
Drum brakes permit safe and con-
venient braking for an attendant.
They can also be applied with the
aid of a locking lever (1). The
locking lever must snap audibly
into place. Performance of the
drum brakes is not dependant on
the air pressure inside the tyres.
The wheelchair cannot be pushed
when the drum brakes are set.
CAUTION!
Drum brakes should only be
adjusted by authorised dealers.
285
1
1
2
(6.2)
Footrest and footrest interlock
(7.23.1)
The footrest can be swung out-
wards. When fitting the footrests
these are installed in the swung-
away position. Then simply turn
them inwards until the interlock
engages (1). To remove the foot-
rests, use the lever (2) and swing
the footrest outwards and lift off.
Check that the footrest is correctly
engaged.
CAUTION!
The footrests are not designed
to be used to lift or carry the
wheelchairs with an occupant.
2
1