2. If the water does not flow out of the fountain, it may be caused by kinked or loose water tubes, make sure water tubes
are connected properly.
ASSEMBLY PICTURES
Fig 1
Fig 2
Fig 3
Fig4
Fig5
Fig 6
Fig7
Fig 8
Fig 9
ASSEMBLY INSTRUCTIONS
Step 1: Place the base pedestal and the large basin on a level surface. route the pump’s power cord downwards
through the resin tube in large basin. Lay the pump in the bottom of the large basin.And then route the pump’s
power cord through the base pedestal, the cord exits through the slot in the bottom of base pedestal.,Lastly align
the large basin with base pedestal, insert the large basin and twist clockwise to lock in place securely. (pls
refer to the fig. 1,2,3)
Step 3: Route the water tube of the fountain topper downwards through the middle hole of the middle pedestal, then
align the fountain topper with the small pedestal. Make sure matching the blocks under the fountain topper to the the
slot on small basin. Insert the fountain topper and twist clockwise to lock in place securely, (pls refer to the fig.4,5,6)
Step 4: Route the water tube of the assembled topper downwards through the assembled large basin. through the
door of Center Pedestal,Connect the water tube to the outlet nozzle of pump. Make sure the connection is
tight.insert the assmbled topper and twise clockwise to lock in place securely. (pls refer to the fig.7)
Step 5: Put the board located at the door of the Center Pedestal (pls refer to the fig.8,9)
Step 6: Fill the large basin and small basin with water. Make sure the pump is completely submerged in water.
Step 7: Plug the pump power cord to the wall outlet to run the fountain.
Summary of Contents for LZH-117
Page 4: ......
