Sunny SF-T7635, User Manual

Page: 12 / 25

11
MAINTENANCE & CARE
General cleaning will help prolong the life and performance of your treadmill. Keep the
unit clean and maintained by dusting the components on a regular basis. Clean both
sides of the running belt to prevent dust from accumulating underneath the belt. Keep
your running shoes clean so that dirt from your shoes do not wear out the running board
and belt. Clean the surface of the running belt with a clean damp cloth.

To better maintain the treadmill and prolong its life it is suggested that the machine be
powered off for 10 minutes every 2 hours and fully powered off whenever not in use.

A loose Running Belt will result in the runner sliding off when running, while too tight of
a Running Belt will result in decrease to the motors performance and also create more
friction between the roller and running belts. The most suitable tightness for the belts is
pulled out
50-75mm from the Running Board.
CENTERING THE RUNNING BELT:
Place the treadmill on level ground and set it at 3-5mph to check if the Running Belt
(C09) drifts.
1. If the Running Belt (C09) moves to
the right, turn the adjusting bolt on the
right side
¼ turn clockwise , then turn
the left adjustment bolt ¼ turn
counter-clockwise . If the belt does not
move, repeat this step until it centers.
Refer to Figure A.
2. If the Running Belt (C09) moves to
the left, turn the adjusting bolts on the
left side
¼ of a turn clockwise , then
turn the right adjustment bolt ¼ turn
counter-clockwise . If the belt does not
move, repeat this step until it centers.
Refer to Figure B.
3. Over time the Running Belt (C09)
will loosen. To tighten the belt turn the
Left & Right
side adjustment bolts one
full turn clockwise , check the tension
of the belt. Continue this process until
belt is at the correct tension. Make
sure to adjust both sides equally to
ensure correct belt alignment. Refer to
diagram
“C”
.