9
STEP 2: ATTACHING THE SPINDLE BAR
Insert the
Spindle Bar (No. 42)
through the
Right Swing Bar (No. 29)
and
Wave
Washer (No. 35)
into the main frame, then through
Wave Washer (No. 35)
and into
Left Swing Bar (No. 27).
Put a
“D” Shape Washer (No. 32)
& a
Spring Washer (No.
31)
on both sides of the
Spindle Bar
, tighten both ends using the
Hinge Screws (No.
30).
Note
:
Before you tighten the
Hinge Screws (No. 30),
ensure the
D Shape
Washers (No.32
) are fully onto the
Spindle Bar (No.42)
.
Insert the
Right Hinge Bolt (No. 9)
through the
Wave Washer (No.35)
and the hole of
the
Right Pedal Tube (No. 21),
screw the
Right Hinge Bolt
“
Clockwise
”
into the
Crank Arm (No. 51) then
slide the
Spring Washer (No. 3)
onto the
Right Hinge Bolt
(No. 9)
and secure the bolt with the
Right Lock Nut (No. 8).
Repeat this assembly process for the Left Side.
*Important Note:
Left Hinge Bolt (No. 1)
has reversed threading, when assembling
the Left Side, you must screw the
Left Hinge Bolt “
Counter-Clockwise” to tighten*.
ATTENTION:
The
Right and Left Hinge Bolt (No. 9 & No. 1)
must fully penetrate the nylon ring
inside the
Pedal Tube (No. 21 & No. 19)
& the
Right and Left Crank (No. 51).
This will
ensure the stability and durability of the Sunny Flywheel Elliptical Trainer.
In order to install hinge bolt properly, keep it perfectly straight as the bolt goes through
the pedal tubing and the crankshaft. If the hinge bolt is connected to the crankshaft at
an angle, damage to both the hinge and the crankshaft may occur.
Summary of Contents for SF-E1405
Page 3: ...3 EXPLODED VIEW DIAGRAM...
