Sunny Health & Fitness SF-T7632, User Manual

Page: 11 / 22

10
MAINTENANCE & CARE
General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean
and maintained by dusting the components on a regular basis. Clean both sides of the
Running
Belt (No. C13) to prevent dust from accumulating underneath. Keep your running shoes clean so
that dirt from your shoes does not wear out the Running Board (No. D12) and Running Belt (No.
C13) . Clean the surface of the Running Belt (No. C13) with a clean damp cloth.
To better maintain the treadmill and prolong its life it is suggested that the treadmill be powered off
for 10 minutes every 2 hours and fully powered off whenever not in use.
A loose
Running Belt (No. C13) will result in the runner sliding off when running, while too tight of
a Running Belt (No. C13) will negatively affect the motor
’s performance and also create more
friction between the roller and Running Belt (No. C13) . The most suitable tightness for the
Running Belt (No. C13) is pulled out 50-75mm from the Running Board (No. D12) .
CENTERING THE RUNNING BELT:
Place the treadmill on level ground and set it at 3-5MPH to check if the Running Belt (No. C13)
drifts.
1. If the Running Belt (No. C13) moves
to the right, turn the adjusting bolt on the
right side
¼ turn clockwise , then turn the
left adjustment bolt ¼ turn
counter-clockwise . If the Running Belt
(No. C13) does not move, repeat this
step until it centers. Refer to Figure A.
2. If the Running Belt (No. C13) moves
to the left, turn the adjusting bolts on the
left side
¼ turn clockwise , then turn the
right adjustment bolt ¼ turn
counter-clockwise . If the Running Belt
(No. C13) does not move, repeat this step
until it centers. Refer to Figure B.
3. Over time , the Running Belt (No.
C13) will loosen. To tighten the Running
Belt (No. C13) turn the Left & Right side
adjustment bolts one full turn clockwise ,
check the tension of the Running Belt
(No. C13) . Continue this process until
Running Belt (No. C13) is at the correct
tension. Make sure to adjust both sides
equally to ensure correct belt alignment.
Refer to Figure C.