10
HOW TO FILL AND EMPTY THE TANK
1. Remove the
Fill Plug (No. 33)
from the
Upper Tank Cover (No. 12)
.
2. To fill the tank with water, refer to Fig. A. Insert the
Funnel (No. 77)
into the tank, then use a cup or
the
Pumping
Siphon (No. 76)
and a bucket to fill the tank. Use the water level gauge on the side
of the tank to measure desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the
Pumping
Siphon
(No. 76)
to pump out the water from the tank into the bucket.
4. Insert the
Fill Plug (No. 33)
into the
Upper Tank Cover (No. 12)
. Wipe excess water off the frame.
NOTE:
•
Fill the tank only with tap water. Add 1 water purification tablet (1 packet is included.). Never use
pool chlorine or chlorine bleach. This will damage the tank and void the warranty.
•
Add a water purification tablet every 6 months or as needed. If water remains cloudy, replace the
water in the tank.
•
Do not consume the tank water. Dispose of the water after pumping it out from the tank.
WATER LEVEL
•
See Fig. A. The water level gauge is on the side of the tank. The maximum fill level is 6. Never
fill over this limit. Filling the tank over this limit will void the warranty.
•
The resistance depends on the water level in the tank. Water level 1 is the lowest resistance. Level
6 is the highest resistance.
Summary of Contents for SF-RW5713
Page 4: ...3 EXPLODED DIAGRAM HARDWARE PACKAGE ...
Page 36: ...35 ...
