Sunny Health & Fitness 012S, User Manual

Page: 9 / 19

8
Version 1.10
EXERCISE METER
KEY FUNCTIONS:
MODE: Press the MODE button to select a function. (Time,
Rep/Min, Count, Calorie and Scan)
OPERATION PROCEDURES:
1.
AUTO ON/OFF:
If the steps of the machine are put into motion or the MODE button is pressed, the meter will
activate and will remain active during use. If it goes without signal for approximately 4 minutes, the
meter will turn off automatically.
2.
RESET
:
The meter can be reset by pressing and holding the MODE button for three seconds. Removing the
batteries will also reset the meter and return all function settings back to zero.
3.
MODE
:
To select the LOCK MODE setting, press the MODE key when the pointer is on the function you
wish to lock. Once locked, only the selected function will be displayed.
4.
FUNCTIONS:
TIME: Counts the total time of an exercise from start to finish.
CALORIES: Counts the number of total calories burned during an exercise from start to finish.
COUNT: Automatically accumulates the count of steps taken during sessions. Meter counts 1 step
after you step once with each foot.
REPS/MIN : Automatically displays the count of steps per minute.
SCAN: Press the MODE button until the indicator arrow points to SCAN. The indicator arrow will
continue to flash indicating that SCAN mode is active. SCAN mode will automatically scan through
each function in sequence.
NOTE:
1.
If you have an inaccurate reading on the meter, please replace the battery immediately. (See
instructions below)
2.
Please use (1) LR44, 1.5V battery.
3.
The meter is auto-powered. It turns on when exercise begins, and it turns off when no movement is
made between 4 to 5 minutes.
4.
All functions will automatically stop calculating when ' STOP ' appears in the upper left corner of the
display monitor. This occurs when there is no signal for a period of 4 seconds. Once the exercise
begins again, the meter will automatically start recalculating.
CHANGING THE BATTERY
1.
Remove the plastic cap from the battery.
2.
Remove the battery using the tool provided or
your fingers.
3.
Insert the new battery using the tool provided or
your fingers. Ensure that the positive side of the
battery which is labeled with a
+ sign is facing
upward once the new battery is in place.
4.
Place the plastic cap over the battery.
5.
Connect the wire onto the meter.
6.
Insert the meter onto main frame.