SMR Pitched Roof System
44
of
48
Shared Rail Roof Attachment
Shared Rail End Clamp Attachment
Shared Rail Mid Clamp Attachment
Install the End Clamp on the Rail at the ends of
the PV panel array. Confirm that the hooks on
the End Clamp are fully engaged with the hooks
on the side of the Rail. Secure the PV panel
frame to the Rail using the End Clamp; use a
6mm hex driver and torque to 9.4 Nm (6.9 ft-
lbs).
Note: For a single panel configuration install
bonding pins into the Bonding Pin Holder of the
End Clamp.
Install the Mid Clamp on the Rail between PV
panels. Confirm that the hooks on the Mid
Clamp are fully engaged with the hooks on the
side of the Rail. Secure the PV panel frame to
the Rail using the Mid Clamp; use a 6mm hex
driver and torque to 9.4 Nm (6.9 ft-lbs).
Adjust the L-Foot up or down the roof slope to
position Rail. Tighten the L-Foot using a 6mm
hex driver and torque to 13Nm (10 ft-lbs).