Production Number: XXXXXXXX
Made In China
7 / 11
LOCATION
Your Gas appliance must be installed on a flat, stable surface, away from any combustible materials or
construction.
SET-UP
Your Gas appliance comes assembled, ready for a Gas connection.
1- Remove the appliance from container box and place it on any level, outdoor, non-combustible
surface.
NOTE: Do not place this appliance on grass or dirt area. This may prevent proper safety venting.
2- Open the gas door and put the cylinder inside.
3- Unscrew the battery box as shown in Fig 7.Insert the negative electrode side of the battery into the
bottom of battery box as shown in Fig 8. Then screw the battery box as shown in Fig 9.
Fig 7 Fig 8 Fig 9
Note: If the battery of the pulse electronic igniter runs out of power, please replace the new battery as
above.
Gas Connection
1- Open the door and put the chain and control valve outside. See Fig 10.
2- Put the cylinder into the cylinder rack. See Fig 11.
3- Connect the regulator and the cylinder as per Fig.12. Make sure there is no leakage or damage
(please refer to
“Leak Test” on page 9 and the damage checking on page 4).
4- Turn the butterfly nut on the cylinder frame, so that the nut is held against the bottom of the cylinder,
to make sure the cylinder can be fixed. See Fig 13.
5- Disconnect the regulator and the cylinder as per Fig.14.
Fig 12
