9
Winding the line
NOTE:
A dual-line factory wound spool (model TRJ609ERS)
is available for easy spool replacement on the TRJ609E
electric grass trimmer. Visit snowjoe.com to purchase this
accessory online. Should you wish to wind the line yourself, the
instructions are provided below. Self-winding, however, is NOT
recommended because if the line is not wound properly it can
cause the trimmer’s bump feed system to malfunction. For this
reason, users are strongly urged to purchase the pre-wound
spool.
1. The spool can hold 16.4 ft (5 m) of line. Remove the white
cover. Holding the loose ends of the line together with
one hand, find the center of the line with the other hand
and hook this center loop into the groove on the spool
(Fig. 15).
2. Wind the line following the directional arrows on the
spool housing and hook the two ends into the side
grooves (Fig. 16).
3. Firmly place the white cover on the spool and pull the
two ends approximately 3.5 inch (9 cm) out of the spool
(Fig. 1
7
).
Fig. 13
Fig. 14
Spool
Fig. 15
Fig. 16
Fig. 17
