10
4. Along the groove, slide the line into the hole in the spool
cover (Fig. 18).
5. Prepare to assemble the spool into the trimmer.
Assembling the spool
NOTE: Users are strongly urged to purchase the pre-wound
spool. A dual-line factory wound spool (model TRJ609ERS) is
available for easy spool replacement on the TRJ609E electric
grass trimmer. Visit snowjoe.com to purchase this accessory
online. When using the factory wound spool, keep the
protective white cover encasing the line in place, then follow
the directions below to feed the line into the grass trimmer.
1. Insert the spring into the shroud and thread the line into
the hole (Fig. 1
9)
.
2.
Place the spool cover on the spool and press it firmly
down until the locking devices of the spool cover securely
click into place (Fig. 20).
m
CAUTION!
Catapulted pieces of nylon line may cause
injury.
NOTE: The maximum recommended length of line in the spool
is 8 ft (2.5 m) per slot.
m
WARNING!
Pay attention to the winding direction.
1. Always replace the spool with a new pre-wound spool.
Visit snowjoe.com to purchase the pre-wound spool
(model TRJ609ERS) for this electric trimmer.
2. Insert the end of the line through the eyelet in the cutting
head.
IMPORTANT: Keep all areas of the cutting head cover and
cutting head clean. Place the cap back by pushing it firmly
onto the cutting head. To ensure that the cutting head cover
is correctly fitted, try to remove it without depressing the two
latches. If it is correctly fitted, it should not move.
Maintenance
m
WARNING!
Make sure to unplug your trimmer before
inspecting its parts.
•
Your grass trimmer requires no additional lubrication or
maintenance. There are no user serviceable parts in your
trimmer. If a fault is suspected, contact your authorized
Snow Joe
®
+ Sun Joe
®
dealer or call the Snow Joe
®
+
Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
•
Your trimmer line can dry out over time. To keep your line in
top condition, store spare pre-wound spools or bulk line in
a plastic, resealable bag with a tablespoon of water.
•
Never use water or chemical cleaners to clean your grass
trimmer. Wipe it clean with a dry cloth.
•
Plastic parts may be cleaned by using mild soap and a
damp rag.
Fig. 18
Fig. 19
Spring
Fig. 20
Locking
devices
Spool cover
Spool
