sunjoe TJ601E, Operator'S Manual

Page: 12 / 16

12
NOTE: After each use, follow these steps to properly clean the
unit:
1. Remove soil, dirt, and foliage stuck in the tines, drive
shaft, tool surface, and vents with a brush or dry cloth.
2. Spray or rub biodegradable oil onto the tines.
3. Clean soiled grips with a damp cloth.
Always inspect the machine for damaged and worn parts after
each use. Check that safety features (i.e. labels, guards, etc.)
are in place. Check that nuts, bolts, and screws are tight.
Changing the Tines
NOTE: The machine is fitted with six tilling blades that can
easily be changed. Both of the steel blade tine pairs can be
fitted on the left or right, as required. Always change both tine
pairs at the same time to avoid imbalance and damage to the
machine.
To replace the tines, follow the steps below:
1. Place the electric tiller on the ground.
2. Remove the hex bolts and the self-locking nuts, then
remove the steel blade tines, noting the way the old tines
come off (Fig. 14).
3. Clean the drive shaft with biodegradable oil (Fig. 15).
4. Place the new tines onto the drive shaft so that the holes
on the axles line up with the holes on the drive shaft,
replacing the new tines exactly the same way (Fig. 15).
5. Insert the hex bolts through the holes and secure them
with the self-locking nuts (Fig. 15).
IMPORTANT: The tines must be set in the correct turning
direction. Note the way the old tines came off and replace the
new ones exactly the same way.
Power Cord
If the power cord is damaged, it must be replaced in order to
avoid a safety hazard. Contact your authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866- SNOWJOE (1-866-766-9563).
Repair
This product does not contain any parts that can be repaired
by the consumer. C ontact an authorized Snow Joe
®
+ Sun
Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service
center at 1-866-SNOWJOE (1-866-766-9563) for assistance.
Storage
• Examine the electric cultivator thoroughly for worn,
loose, or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
• Examine the extension cord thoroughly for signs of excess
wear or damage. If it is worn or damaged, replace it
immediately.
• Disconnect the extension cord from the electric
cultivator before storing.
• Allow the motor to completely cool down before storing the
cultivator.
• Clean the product as described above.
• Store the product and its accessories in a dark, dry,
frost-free, and well-ventilated place.
• Always store the product in a place that is inaccessible to
children.
Fig. 14
2 Hex bolts + 2 Self-locking nuts
Fig. 15
Drive shaft Hex bolt Steel blade tines
Self-locking
nuts