9
2. Two extension tubes are equipped with the unit. Insert
the vacuum hose into the first extension tube, and turn
counterclockwise to lock. Follow the same instruction to
assemble the second extension tube (Fig. 9).
3. Select the desired accessory, connect it with the end of
the extension tube, turn counterclockwise to lock securely.
Your wet/dry vacuum is ready for use (Fig. 10).
Operation
Using the Pressure Washer
m
WARNING!
The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 11).
3.
Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the
rating plate.
If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 12).
Fig. 9
Vacuum hose
Extension tube
A
Extension tube B
Fig. 10
Extension tube
Selected
accessory
Fig. 11
RESE
T
TEST
Fig. 12
GFCI
Power light
indicator
Reset
Summary of Contents for SPX7000E
Page 18: ...NOTES 18 ...
