sunjoe SPX3000-XT-RM, Operator'S Manual

Page: 8 / 20

8
Technical Data
Rated Voltage ......................................................120V ~ 60 Hz
Motor ............................................................................ 13-amp
Max Water Inlet Temperature ................................. 104ºF/40ºC
Max Water Inlet Pressure ............................................ 0.7 MPa
Max Pressure at initial discharge ................................ 2200 PSI
per CSA internal pressure testing
Rated Pressure under typical load ............................. 1700 PSI
Max Flow with nozzle open ...................................... 1.65 GPM
at minimum pressure
Rated Flow under typical load .................................... 1.2 GPM
Hose Length .............................................................. 20 ft (6 m)
Detergent Bottle Capacity ...................................
33.8 fl oz (1 l)
Power Cord Length ................................ 35 ft (GFCI Protected)
Net Weight ..................................................... 27.6 lbs (12.5 kg)
Unpacking
Carton Contents
• Electric pressure washer
• Transport handle
• Trigger gun
• Stainless steel lance
• Four (4) Quick-Connect nozzles (0º, 15º, 25º, and 40º)
• D
etergent bottle with foam cannon
• Four ( 4) large screws
• Two (2) small screws
•
Spray wand protector
• Trigger gun holder
• Hose holder
• Needle clean-out tool
• High-pressure hose
• Garden hose adapter (female coupler) with two sealing rings
•
Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Assembly
1. Position the washer as CLOSE as possible to the
water supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 1).
3. Slide the trigger gun holder into position (Fig. 2).
4. Slide the transport handle into position and secure it with
4 large screws (Fig. 3).
Fig. 1
Fig. 2
Trigger gun holder