sunjoe SPX160E-MAX, Operator'S Manual

Page: 7 / 48

7
Technical Data
Rated Voltage ......................................................120V ~ 60 Hz
Motor ............................................................................ 11-amp
Max Water Inlet Temperature ................................. 140°F/60°C
Max Water Inlet Pressure ............................................ 0.7 MPa
Max Pressure at initial discharge ................................ 1600 PSI
per CSA internal pressure testing
Rated Pressure under typical load ............................. 1100 PSI
Max Flow without the nozzle attached ..................... 1.63 GPM
Rated Flow under typical load .................................... 1.2 GPM
High-Pressure Hose Length ....................................... 20 ft (6 m)
Foam Cannon Bottle Capacity ........................ 15 fl oz (450 ml)
Power Cord Length ................................ 35 ft (GFCI Protected)
Net Weight ....................................................... 13.4 lbs (6.1 kg)
Unpacking
Carton Contents
• Electric pressure washer
• Pressure hose
• Trigger gun
• Middle extension lance
• Front extension lance
• Turbo nozzle
• Spray nozzle
• Detergent bottle with foam cannon
• Needle clean-out tool
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
materials until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging materials are
not toys. Do not let children play with plastic bags,
foils, or small parts. These items can be swallowed
and pose a suffocation risk!
Assembly
1. Position the washer as CLOSE as possible to the
water supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 1).
Fig. 1
3. Align with the guide line and mount the spray wand holder
on the washer (Fig. 2).
Fig. 2
4. Connect one end of pressure hose to the trigger gun.
Connect the other end to the washer water outlet and
reinforce the connection by the sleeve (Fig. 3-4).
Fig. 3