sunjoe SJ-PSGB, Operator'S Manual

Page: 9 / 16

9
Leakage Test
All connections of this gas fire pit have been checked at the
factory for leakage. However, in transportation and handling
some connections may have loosened. It's recommended to
run the leakage test every time before using and after parts
replacement.
m
WARNING!
• Do not use an open flame to check for leakage.
• Do not smoke during testing.
• Do not test indoors.
• A leak check must be performed whenever the gas cylinder
is replaced.
NOTE: Use only the pressure regulator supplied with this fire
pit. Replace it with those specified by the manufacturer
only.
1. Make leakage solution by mixing 1 part liquid dish soap
and 3 parts water.
2. With the cylinder connected to the hose, spoon or brush
several drops (or use squirt bottle) of the solution onto the
connections along the hose, regulator and cylinder
(Fig. 19).
3. Turn on gas cylinder. Inspect the connections and look for
bubbles.
4. If no bubbles appear, the connection is safe. If bubbles
appear, there is leakage. Loosen and re-tighten this
connection. If there is still a leak, turn off the cylinder
and contact the Snow Joe
®
+ Sun Joe
®
customer service
center at 1-866-SNOWJOE (1-866-766-9563).
At least once a year, a complete inspection of the entire gas
path components should be performed by a professional
technician.
Lighting
Your fire pit was designed and approved for OUTDOOR USE
ONLY. DO NOT use it inside a building or any other enclosed
area.
Make sure surrounding areas are free of combustible
materials, gasoline, and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation. Be sure
all gas connections are tight and there are no leaks. Be sure
the access panel is clear of debris. Be sure any component
removed during assembly or servicing is replaced and fastened
prior to starting.
m
DANGER!
Lighting operations should comply with
the instructions below. Improper lighting operations will cause
serious injury and explosion.
m
WARNING!
The gas fire pit should be thoroughly
inspected before each use, and by a qualified service person
at least annually.
1. Make sure the On/Off knob is in the OFF position.
2. Turn the LP cylinder gas valve to fully open position.
3.
Press down the On/Off knob and turn it counterclockwise
to LOW position, this will light the burner (Fig. 20).
4. When burner is lit, turn the control knob to desired heat
output position between "LOW" and "HIGH".
5. To relight the fire pit, wait at least 5 minutes after turning
off the fire pit.
Fig. 18
Propane gas
cylinder
Cylinder connector
Fig. 19
Fig. 20
On/Off
knob