sunjoe iON8PS2-CT, Operator'S Manual

Page: 15 / 24

15
6. To turn the tool OFF, release the trigger switch.
7. Lift the push lock button and pull out the battery (Fig. 14).
Adjusting the Telescoping Pole
1. Turn off the trigger switch.
2. Unclip the cam-lock to release the pole (Fig. 20).
3. Extend the pole to the desired length (Fig. 21).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb to be cut.
4. Lock the pole in position by closing the cam-lock (Fig. 22),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
m
WARNING!
Failure to lock the telescopic pole cam-lock
as directed could result in personal injury.
Tightening the Bolt
The retaining bolt may need tightening to secure the telescopic
pole in place.
1. Unclip the cam-lock. Using a hex key wrench, tighten the
cam-lock nut, then close the cam-lock. Ensure that the
pole is secure. The wrench may be required to loosen the
cam-lock nut if you need to adjust the pole to a different
height (Fig. 23).
Adjusting the Multi-Angle Head
The pole chain saw head can be rotated for different
cutting angles: 0º or 30º.
1. Turn off the switch.
2. Press the multi-angle head adjustment button to loosen
the head (Fig. 24).
Fig. 19
Safety lock switch
Trigger switch
Fig. 20
Cam-lock
Fig. 21
Telescopic pole
Fig. 22
Cam-lock
Fig. 23
Hex key wrench
Cam-lock nut