14
Edging
1.
To convert for maintenance edging, turn OFF the tool and
remove the battery.
2.
To use the edger guide + flower guard, flip it down from its
stored position (Fig. 21
).
3. Pull up edging coupler and turn the rear handle
counterclockwise and release (Fig. 22). T
he tool is locked
in edger mode.
4. Rotate the whole unit 180 degrees. The tool is now ready
to be used in edger mode (Fig.
23).
5. Use the edge of the guard as a guide when cutting near
fences and walls (Fig. 24).
6.
Move the
edger in a backwards direction when trimming
around edges to avoid damage.
m
WARNING!
Do not trim near electrical wires.
Advancing String
NOTE:
Your trimmer uses 0.047 in. (1.2 mm) diameter nylon
line to cut grass and weed quickly and easily. In time, the
tip of the nylon line will become worn and the auto-feed
mechanism will automatically feed and trim a fresh length of
line. The cutting line will wear faster if the cutting is done along
sidewalks or other abrasive surfaces or heavier weeds are
being cut.
The t edger is equipped with an auto-feed head.
Bumping the head to try to advance the string will damage
trimmer.
1.
With the unit running, release the ON/OFF switch trigger.
2.
Wait two seconds, and press the ON/OFF switch trigger.
Fig. 21
Edger guide +
flower guard
Fig. 22
Pull up edging
coupler
Rear
handle
Fig. 23
Fig. 24
Summary of Contents for 20ViONLTE-ST11-RM
Page 20: ...20 NOTES ...
Page 21: ...21 NOTES ...
Page 22: ...22 NOTES ...
Page 24: ...sunjoe com ...
