www.sunheater.com
7
IF A COLLECTOR DEVELOPS A LEAK
Your solar collectors are warranted against defects in materials and workmanship (see warranty for details and limitations).
If a leak develops for any other reason, you may use the repair method shown. The collectors are not warranted against freeze damage.
SOLAR COLLECTOR REPAIR
This method allows for an easy and permanent, on-site repair of a collector by isolating the leading riser tube. Referring to the
figure at the right, locate the tube to be isolated. (End tube has been shown for clarity). Using a sharp utility knife, very carefully
cut away approximately 1" (2.54 cm) of the tube at both headers. Drive a #10 sheet metal screw, preferably stainless, into the
hole in the header. The screw must be between 1/2" (1.27 cm) and 3/4" (1.9 cm) long. DO NOT OVER-TIGHTEN!
If the screw strips out, or if the repair leaks, use a #12 screw. This repair method will not void the collector warranty.
With proper care and winterization, you will enjoy your solar collectors for many years.
7
WINTERIZATION
COLLECTOR REPAIR
YOUR SOLAR SYSTEM MUST BE DRAINED FOR WINTERIZATION! FREEZE DAMAGE IS NOT COVERED UNDER WARRANTY! YOU
MUST DRAIN YOUR SOLAR COLLECTORS JUST LIKE YOU DRAIN THE REST OF YOUR POOL EQUIPMENT!
Remove the vacuum relief valve at the top of the solar system. Remove the rubber end cap at the bottom and be sure ALL the water is drained out of the system. Replace end
caps and blow pressurized air in the reverse direction of normal water flow. This is the most effective way to drain your system. You can leave the collectors in place (as long as
they are completely drained) and they will withstand even the harshest winters. SPQ Brands recommends that you store your collectors inside in a warm dry place.
AVAILABLE KIT OPTIONS
SK22: HARD PLUMB SYSTEM KIT
Kit Components
Qty
1.5" Diverter Valve
1
3.75" Rubber Hose Connector
1
Pipe Adaptor
2
End Cap
1
Vacuum Relief Valve
1
Spring Check Valve
1
1.5" Stainless Steel Clamps
3
• Used for hard plumb installation
• Will support up to (8) S140U systems or (4) S240U
SK35: MANUAL DIVERTER VALVE KIT
Kit Components
Qty
1.5" Ball Valve
1
1.5" PVC Tees
2
Flex Hose Adaptors
4
• Used for flex hose installations.
• Will support S140U and S240U systems.
SK43: MOUNTING KIT
Kit Components
Qty
6' Web Strapping
5
Stainless Steel Mounting Brackets
15
#14 Stainless Steel Screws
15
• Used for mounting on roof, rack or fence.
• Will support up to (2) S140U or (1) S240U system(s).
SK34: HIGH WIND ADD-ON MOUNTING KIT
Kit Components
Qty
6' Web Strapping
4
Stainless Steel Mounting Brackets
4
#14 Stainless Steel Screws
4
• Used in conjunction with SK43 in areas of excessive wind.
• Will support (1) 2' x 20' collector.
