12
User's Manual
User's Manual
VOLTAGE SEL
ECTOR
100-120 V
T10AL 250V
220-240 V
T6AL 250V
50/60 Hz, 900 W
Instructions for Auto EQ:
• Plug in the XTEQ and turn on the power
using the power switch on the back
panel of the system.
• Please make sure that the microphone
(supplied) is attached through the
microphone input in the back panel
of the box.
• The power indicator will turn red and
confirm that it is “on”.
• In order to continue with the Auto EQ
process, you’ll have to take the system
out of standby mode.
• To do so, press the start button again.
• The Power LED indicator should turn off.
To Launch the
Auto EQ Process:
• Push start.
• The LED indicator will turn blue in color.
• The system will generate a set of tones
and will automatically adjust the proper
level at four seperate frequencies.
(The four frequencies are 35Hz,
49Hz, 64Hz, 84Hz.)
• When finished the blue light will turn off.
Room Equalization Procedure
To utilize effectively, please follow
the steps outlined below:
1. Install the subwoofer in the best location
for your room (see previous section).
2. The calibration must be done while the
listening room is quiet. Please turn off
any noisy machinery, including heating
or cooling systems during this process.
3. Place the microphone in the listening
position (on the couch, for example),
pointing in the direction you’ll normally
be facing while listening to your system.
Only use the microphone supplied by
Sunfire for this process.
4. Plug the microphone into the
subwoofer’s microphone jack (MIC
Input) located on its back panel.
5. back panel controls and connections
should be set as the following:
a. Nothing should be connected
to any of the Input connection
terminals (Left / Right or XLR)
b. Level should be set to “0” db.
c. Crossover should
be set to “bypass”.
d. Phase should be set to “0”.
e. EQ ON/OFF should be
switched to “ON”.
When configuring Auto or Manual EQ,
positioning the Auto EQ button to “on” will
enable you to create your own preferred
settings instead of using factory settings.
9901375_Rev-A_Sunfire_XTEQ_User_Manual_0812_PRINT_ENG.indd 12
8/12/14 7:10 PM
