1003 Rev. A, 1006 Rev. B, 1012 Rev. A
2
10/18/17
WARNING INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THESE STANDS, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these stands. It is also the responsibility of
the stand owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost
or not legible, contact an authorized Sunex repair center for replacements. If the operator is not fluent in English, the product and safety
instructions shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee,
making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical means,
but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the
use and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its
proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack stands before each use. Do not use if damaged, altered, modified, in poor condition, or have loose or missing
hardware or parts. Make corrections before using the stands.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Use as a matched pair only.
• Do not use beyond rated capacity. Do not shock load.
• Maximum load capacity per matched pair shall not exceed the rated capacity of the individual stand.
• Use only on a hard level surface capable of supporting the load.
• Stands are to be used in matched pairs to support one end of a vehicle only. Do not simultaneously support both ends or one side of
a vehicle.
• Apply the emergency brake, put the gear shift lever in park or gear if a manual shift transmission, and chock the tires that will not
be lifted off the ground.
• Center load on saddle. Do not use saddle lugs to support the load.
• Check the stands for solid contact with the ground and vehicle.
• Ensure both stands are set at same height and locking pawls are fully engaging the support column's teeth.
•
Do not crawl under vehicle when placing/removing stands.
• Consult the vehicle manufacturer for the proper frame support locations.
• No alterations shall be made to these stands.
• This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm.
Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING
WARNING
WARNING
WARNING