DCF400 User’s Guide
Version: 04-06-22
3 of 8
•
This appliance operates on
12 or 24 Volts DC
(Direct Current) only!
•
Under no circumstances should this appliance be directly connected to an AC (Alternating Current) power
source.
•
Be sure that the appliance does not stand on the electrical supply cable. Also, be sure the electrical cable is not
squeezed or bent when the appliance is being installed or moved.
•
Installation work and adjustments on the appliance must be carried out by qualified personnel only. Work
performed by persons with inadequate technical knowledge may adversely affect the performance of the
appliance, causing damage to the equipment, and void the warranty.
•
It is dangerous to make alterations or attempt to modify this product in any way. Product alterations will void
the warranty.
During Use
•
Do not store any containers with flammable vapors or liquids in or around the appliance, such as organic solvents,
spray cans, gas cans, etc
.
Servicing
•
This product should be serviced by an authorized technician and only genuine spare parts should be used.
•
Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced
persons may cause injury or serious malfunctioning of the appliance. Unauthorized work may void the warranty.
At the end of the appliance life
When disposing of your appliance, use an authorized disposal site. The refrigerant must be completely drained and
collected by an authorized technician for recycling prior to disposal. Check with your local Environmental Agency for
recommendations on recycling this appliance in your area. Remove the electrical connection wiring and also ensure that
the lid is removed.
INSTALLATION
Unpacking and Cleaning
Remove all packaging and securing tapes from the appliance. If needed, wash the inside and outside of the
appliance with lukewarm water and a mild soap or detergent. Abrasive or corrosive cleaning agents, steel
wool, scouring sponges, or chemical cleaning agents should not be used. A sponge, soft brush or towel is
recommended. After cleaning, thoroughly rinse and dry. You may want to leave the lid open allowing the
compartment to ventilate for 20-30 minutes to get rid of residual odors.
Positioning
The area in which the appliance is to be installed must be relatively cool, dry, and suitably ventilated. The area
must be protected against any beating rain and free of abundant dust. To ensure proper function, the appliance
must be placed horizontally on a flat, firm, and stable surface resting level on all four supports. The floor must
be sufficiently strong enough to support a fully loaded cabinet. Use wood or metal shims to level the appliance
if necessary.
Do not place the appliance close to heat sources (heater, stove, boiler, chimney, etc.), and avoid prolonged
exposure to direct sunlight. This appliance uses the exterior walls to transfer heat from the inside of the
cabinet. Ensure that there is adequate space between the appliance and neighboring walls or large objects.
A
minimum spacing of 3 inches (7.5cm) is highly recommended.
This will provide sufficient airflow around
the appliance resulting in more efficient operation and longer appliance lifetime. Always keep the air vent
openings of the compressor housing cover free from dust and obstructions.
ELECTRICAL DC CONNECTION
The appliance should be left for 2 hours after positioning before it is turned on, to allow the refrigerant oil to settle. If the
appliance has been handled standing on its side or on end, it should be allowed to stand in the normal operating position
for 12 hours before turning it on.
