Sundance Spas ALTAMAR, Owner'S Manual, Page: 64 / 96

Page 58
880 SERIES
12.4 Cleanup Cycle
The cleanup cycle occurs once per day at 12:00 pm (noon). This is not
user programmable. Turning off the corresponding jets pump that is
running can deactivate the feature.
• One Pump System - Jets Pump 1 and the Circulation Pump turn on
for 1 minute and then shut off. Then the blower turns on for 1 minute
and then shuts off.
• Two Pump System - Jets Pump 1 and the Circulation Pump turn
on for 1 minute and then shut off. Then Jets Pump 2 turns on for 1
minute and then shuts off. Then the blower turns on for 1 minute and
then shuts off.
• Three Pump System - Jets Pump 1 and the Circulation Pump turn
on for 1 minute and then shut off. Then Jets Pump 2 turns on for 1
minute and then shuts off. Then Jets Pump 3 turns on for 1 minute
and then shuts off. Then the blower turns on for 1 minute and then
shuts off.
12.5 Blow-Out Cycle
This cycle will purge the air from the plumbing lines normally caused by
draining and filling the spa. The Jets Pump 1 and the Circulation Pump
will turn on for 1 minute and then shut off. Then Jets Pump 2 will turn on
and run for 1 minute then shut off. Lastly, Jets Pump 3 will turn on and
run for 1 minute then shut off. Turning off the corresponding jets pump
that is running can deactivate the feature. This cycle will
only
occur at
start up and after exiting a service lock.
12.6 Water Care Programming
Water care is crucial to maintaining a healthy and clean spa. The
CLEAR RAY water purification system leads the way by sanitizing the
water using a UV light bulb. Your spa can be programmed to remind you
when to check and replace certain components.
From the Settings Menu, tap or to highlight the “Water Care” menu
tab, Figures 12.6a and 12.6b. Tap
Water Care
to the enter the menu.
Then select one of the features.
SETTINGS
Water Care
WiFi
Heat & Filter
Water Care
CLEARRAY
Water Refresh
MicroClean Inner
MicroClean Outer
65
60
50
60
A
A
A
A
Figure 12.6a
Figure 12.6b