Page 60
880 SERIES
PrOBLeM
PrOCedUre
Poor jet acton
(See Figures
F-J, pages
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (pages 49-50).
Water is too
hot
1. Reduce thermostat setting (page 27).
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed filter cycles
No heat
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If “heater on” indicator is lit but no
temperature rise is experienced after a reasonable
period of time, contact your Sundance Spas dealer
or qualified service technician.
Filter/
circulation
pump off
1. Verify filter/circulation pump is programmed to run
2. Filter/circulation pump cycle canceled by power
interruption. Wait 24 hours for hot tub to reset or
press select button for manual activation.
3. Hot tub water is warmer than 95°F (35°C) and two
degrees warmer than the set temperature. The
“Summer Logic” safety feature has activated. See
note on page 46 for details.
Should checking the above steps fail to correct the problem, please call
your authorized dealer so that he may arrange service.
Sundance builds the best hot tubs in the industry. Nonetheless, we are
always striving to improve the quality and features of our products. Your
input as a Sundance hot tub owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your hot tub, please write to us.
CONGrATULATiONS
on your good taste and welcome to the happiest
and most relaxed family in the world!
