Sunco SO91, Manual

Page: 8 / 17

Operation
1.Inserting Micro SD Card
Note: Please choose branded Micro SD card and format it on computer ,before use. Neutral cards are not
guaranteed to worknormally.
2. Installing and removing battery
A.The battery door has been locked when the lock catch is in the”LOCK”, push the lock catch to “ ”,then to
“ ”, the battery door will be open again.
B.Correctly install battery into camera as indicated by+/- symbols and direction of arrows marked on battery until
it’s in place.
C.About battery power: please refer to the symbol: Full power mode “ ” low power mode“ ”.
D.Remove battery: Open the battery cap and take battery out.
Note: Please push the lock catch to the position of”LOCK” before use the device in case that battery looses or falls
in the process of using.
3.Battery Charging
A.Camera can charge by either connecting it to computer or power adapter.
B.Charging camera on vehicle by connecting it to carcharger.
C.Camera can record video while charging(switch into Vehicle-mounted Mode in “menu”).
D.Charging can be done even when it’s powered off.
4.Power mode
Press and hold power for 3-5 seconds to turn iton/off.
5.Mode Switching
Switching between video recording/photo shooting/playback/menu by pressing “PowerOn-Off”button.
6.WIFI Control
Before use WIFI Control function, please install GoAction software to your mobile phone or tablet PC.
Note: Android phone downloads APP in Google Play. IOS phone downloads APP in Apple Store.
Connection Steps:
1.After switching camera on, press the WIFI button for 2 seconds and turn on/off WIFI function.( WIFI icon will be
display or disappear at the top right of the screen.) When turning on WIFI function, camera will reset. WIfi icon
become green after reseting and waitig for 5 seconds.(It expresses that WIFI can be connected normally now.)
2.Open the WIFI connection of mobile phone to search for the camera device: AMBA A12—XXXX from the
available wireless networks. (Password is 1234567890.)
3.Open the installation of GoAction software
7. Start the camera, shift to setting menu, find "Bluetooth Pair", then press "OK" button,the camera will display
"Bluetooth Pair Start", at the same time, press any key on the remote control, it will flash blue light. On the camera
screen, it displays "Bluetooth Pair", after around 20 seconds, you could see " Bluetooth Pair Success!", that means
connect successfully, then back to normal mode.
7. Start the camera, shift to setting menu, find "Bluetooth Pair", then press "OK" button,the camera will display
"Bluetooth Pair Start", at the same time, press any key on the remote control, it will flash blue light. On the camera