z
Do not use rotary blowers to convey or handle explosive or damaging gases.
z
Because of the high temperatures generated (up to 313
̧
), do not touch
pipes or ancillaries during operation of the rotary blower. Wait until the
blower has cooled down and pressure is vented before performing any
repairs.
z
Only specially trained personnel should work on power driven systems.
5.3 General References
The rotary blower is not capable of functioning as an independent
machine: it is designed as a sub-component to be used and controlled
within a bigger system.
The rotary blower may only be put into operation as an integral part
of a complete system that has been subjected to a safety inspection
proving that it conforms to the requirements of relevant safety
regulations (see OSHA CFR 29, 1910)
6. Arrival and Use of the Rotary Blower
6.1 Arrival Inspection
Before accepting the shipment, perform the following
inspections:
z
Review the packing slip and verify that all components and
accessories are included and undamaged. Uncrate or remove,
from packing, all items and inspect them thoroughly. Report
any damage or missing items described on the packing slip
with the carrier.
z
Rotate the shaft and insure smooth rotation by hand. If the
contamination covers are still on the inlet and outlet of the
unit, expect some resistance when turning the shaft..
-----------------------------------------------------------------------------------------------------------------------------------------------
Sunco Blowers www.suncoblowers.com
Phone: 704-545-3922 Pg. 14
All rights reserved. No part of this manual may be reproduced in any form by any
means without permission from
Sunco Blowers
