SAFETY INFORMATION
READ ALL WARNINGS BELOW.
FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
•
Carefully read and adhere to all CAUTION and NOTE notices located throughout this manual. Failure to
comply with these instructions can cause serious injury, death, or damage to the unit.
•
Do NOT allow children to operate this product.
•
Always turn the filter system to a setting that does not allow flow to the pool return when installing or
working on the solar heater.
•
Install product away from the pool to prevent children from using the heater as a way to access the pool.
•
NEVER service this unit with the pool pump running.
•
Do not use any petroleum-based lubricant. Petroleum based products will destroy plastic parts.
THESE CAUTION WARNINGS ARE NOT INTENDED TO INCORPORATE
ALL POSSIBLE INSTANCES FOR RISK AND/OR SEVERE INJURY.
THE POOL OWNER SHOULD ALWAYS EXERCISE CAUTION
AND COMMON SENSE WHEN UTILIZING THEIR SWIMMING POOL
AND OPERATING EQUIPMENT.
GENERAL INFORMATION
This manual provides a detailed step-by-step procedure for the installation of a
Sunburst Above Ground Solar
Pool Heating System
. If the directions are followed correctly and only recommended Sunburst hardware and
components are used, the installed system should provide years of trouble-free service, savings and enjoyment.
HOW IT WORKS
This product is a solar heater for above ground pools that uses existing pool pump to circulate the pool water
through the solar panels. The system is to be installed in between the pool filter and the pool inlet supply line.
The pump will send water from the pool to the system where it is heated, then returned to the pool via the pool
inlet supply line hose. It is important to set up your pool heater, so the solar panels receive as much sunlight as
possible to achieve maximum efficiency.
2
TOOLS REQUIRED FOR INSTALLATION
•
5/16” nut driver or ¼” flat blade screwdriver
•
Plugs for pool return and supply lines
