Installation Instructions
SB-WM46
9
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the SB-WM46 up to (and
including) the display does not exceed 150 lbs (68 kg).
1.
Align slots on upper portion of faceplate (E) with tabs on
upper portion of arm assembly (A). Lower display into place,
pivoting threaded stud on faceplate (E) into slot on arm
assembly (A). (See Figure 11)
2.
Install spacer (N), locking bracket (T), and nut (Q) onto
threaded stud. Tighten securely. (See Figure 11)
Figure 11
3.
(Optional) Install padlock through locking bracket (T). (See
Figure 12)
NOTE:
Padlock should have a shackle diameter of 1/4" or
5/16" and a clearance height of 1".
Figure 12
Cable Management
CAUTION:
Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched by
installation of covers (W) or screws (R).
1.
Carefully insert cables into cavities located in lower portions
of mount arms. (See Figure 13)
2.
Install each cover (W) with two screws (R). (See Figure 13)
Figure 13
3.
Use cable ties (not included) to secure cables to wall mount
at cable slot locations. (See Figure 14)
Figure 14
1
2
1/2” (12.7mm)
(N)
(T)
(E)
(A)
(Q)
(short interface models
shown)
(T)
3
(R) x 8
1
2
(W) x 4
(W)
