Step 3: Attach the Extension Pole
Thread in extension pipe so that the holes in the pipe align with the
holes in the bracket, then tighten the through-bolt and tighten the set
screw (Fig. 4).
Step 4: Attach the Mount Head
a. Inserting through-bolts on adapter plate through angled slots in
mounting head. Place M8 washers and nylon-insert nuts on end of
through-bolts and tighten down (Fig. 5).
b. Screw mount head onto end of extension pole and tighten set
screws (Fig. 6).
Step 5: Attach the TV Arms to the Display
Attach the TV arms to the display using M4, M5, M6, or M8 screws.
For displays with a hole pattern in a pocket or inputs behind adapter
plate, spacers go between TV arms and display (Fig. 7).
Step 6: Attach the Display to the Ceiling Mount Assembly
a. Hang the display on the wall arm assembly by the TV arms,
ensuring all three hooks slide into holes of mount head (Fig. 8).
b. Using a Phillips screwdriver, tighten down locking screws at the
bottom of each TV arm, ensuring that the screws hold the arms
captive to the bracket (Fig. 9).
c. Insert locking pin (Fig. 10).
ADJUSTMENTS
Tilt Adjustment
a. Loosen screws on side of mount head (only enough to allow
controlled adjustment), then adjust tilt forward or backward.
b. Retighten screws, then make sure that the tilt angle is locked.
Horizontal Adjustment (Roll)
a. Slightly loosen all four nylon-insert nuts behind the adapter plate,
only to allow movement of the plate.
b. Using the corners of the TV, adjust left/right until level. Re-tighten all
nylon-insert nuts.
WARNING: Completely loosening and/or removing nuts may
cause plate and/or TV to fall, causing serious injury.
Fig. 5
Fig. 6
WARRANTY AND LEGAL INFORMATION
Find details of the product’s Limited Warranty at
snapav.
com/warranty
or request a paper copy from Customer
Service at
866.424.4489
. Find other legal resources,
such as regulatory notices and patent information, at
snapav.com/legal
.
Technical Support: 866.838.5052
Fig. 9
Fig. 10
Fig. 7
Fig. 8
Fig. 4
200-SB-CM-T-L-BL-001 Rev B 20210524MS
Copyright ©2021, Wirepath Home Systems, LLC. All rights reserved.
Control4 and SnapAV and their respective logos are registered
trademarks or trademarks of Wirepath Home Systems, LLC, dba
“Control4” and/or dba “SnapAV” in the United States and/or other
countries. Snap AV, SunBriteDS, SunBriteTV, Wirepath, and
Wirepath ONE are also registered trademarks or trademarks of
Wirepath Home Systems, LLC. Other names and brands may be
claimed as the property of their respective owners. SnapAV makes
no claim that the information contained herein covers all installation
scenarios and contingencies, or product use risks. Information within
this specification subject to change without notice.
