Page 8
TV Installation - Table Top Stand Installation
Table Top Stand Installation
Tools Needed: Phillips screwdriver
Notes:
a. Do not attach the Table Top Stand if you plan to install the TV on a wall
mount or ceiling mount.
b. The Speaker Module must be installed before attaching the Table Top
Stand .
For demonstration purposes, this manual is showing how to install the right-
half of the Table Stand. Because you will be working from the back of the TV,
the Table Stand will appear on the left.
1. Prepare a flat work surface, free of any debris or items which may scratch the
front surface of the TV.
2. Lay the TV face-down on the work surface with the bottom of the unit closest
to you
WARNING: Use at least two people when transporting the TV.
3. Position the TV so that the bottom edge overhangs the table by about two
inches.
4. The TV is shipped with four Table Top Stand Mounting Screws. Two are on
the back of the TV, and two are on the back of the installed Speaker Module.
Temporarily remove the Table Top Stand Mounting Screws. (Figure 1).
Note: Important Note: Always replace mounting screws. Failure to do so will
allow water to seep inside your TV. This can cause serious injury and can
damage your TV.
5. The Table Stand has adjacent Mounting Holes, one on the back and one on
the bottom (Figure 2).
6. Place the Table Stand on the TV so that the Table Stand Mounting Holes align
with the TV Mounting Holes, and replace the Table Stand Mounting Screws to
attach the Table Mount to the TV and secure tightly (Figures 3 and 4).
7. Follow procedures 4 thru 6 to install the other Table Top Stand on the right
side.
Figure 2
Table Top Stand
Figure 3
Figure 4
WARNING:
To prevent personal injury and/or
damage to the TV or personal property, use at
least two people to install or move the TV.
Table Top Stand
Mounting Holes
Figure 1
Table Top Stand
Mounting Screw
on TV
Table Top Stand
Mounting Screw on
Speaker Module
