9
Filtering chilled water.
• Push the Chilled/Filtered button and use either
the manual water dispenser button or the
continuous flow button. The unit will dispense
up to 1.1 litres of chilled water at a time. If the
entire 1.1 litres of water is dispensed, the unit
will require time to chill the water again. The
ready light will indicate that the unit is able to
dispense chilled water.
• After fitting a new filter always flush out the
filter before use.
• To do this, simply filter one full tank.
• The appliance should be left overnight to chill
after flushing.
Filter life.
• The life of your filter will be affected by the
quality of your tap water. When you notice that
the water begins to flow very slowly from the
spout it is time to change the filter. However,
you should replace the filter at least every six
months. In addition to the Super Fine Filter
supplied with the appliance, a longer lasting
General Purpose Filter is also available. This
filter will not remove giardia or
cyptosporodium.
Replacing the filter.
Removing the filter
• Switch off and unplug the appliance.
• Remove the water tank.
• Remove and discard the old filter.
• If black O-ring seals remains inside the
appliance remove and discard them.
Installing the new filter
• Remove the two clear plugs from the new filter
• Wet the new O-ring seals and snap the filter
into place.
• Place a tank of water on the base and plug
the appliance into the power outlet.
• Flush the filter as explained above.
If the appliance has not been used for more
than two weeks, flush the filter before use.
Using your Water Filter and Chiller (continued)
