10
Using your 6 heat digital timer control
BL54 Quilted
BL55 Pillowtop
BL56 Wool Fleece Series
Before first use
Before using your electric blanket for the
first time, Sunbeam recommends that you
switch the blanket to maximum heat (setting
6) for two to three hours to evaporate any
moisture in the mattress. Repeat this process
every few months to maintain a dry, healthy
bed. Your electric blanket control has 6 heat
settings, which are recommended for use as
follows:
1-3 Low, gentle heat for all night use
4-5 Medium heat or all night use
6 Fast, preheat only
Use setting 6 to preheat your bed only.
Do not sleep with your blanket on this
settings for more than 30 minutes.
Ensure that the control is connected to the
blanket properly. Move the slide switch on
the rear of the control to the on position (I).
The blue standby light (
) will illuminate to
indicate that the blanket is connected to the
power outlet but is not heating.
Press the timer button (
) to turn the
control on. Heat setting 1 will illuminate.
Select the desired temperature using the
temperature ( ) button. The selected
temperature setting will illuminate.
Pressing the temperature button cycles
through the various temperature settings,
from 1 through to 6, then back to 1.
To change the timer period, press the timer
button (
). Pressing the timer button will
cycle through the two timer options, 1 hour
or 9 hours, and standby mode. If the timer
setting is changed during the timer period,
the timer will restart.
At the end of the selected timer period, the
blanket will switch off and the blue standby
light will illuminate. To switch the blanket
on again, press the timer button to select a
timer period. The control will default to the
previous temperature setting. You can adjust
the temperature at any time during the timer
period.
Figure 5.
