![background image](http://html1.mh-extra.com/html/sunbeam/sbfnss1/sbfnss1_instruction-manual_1394654006.webp)
5
OPERATING INSTRUCTIONS
BATTERY INSTALLATION
IMPORTANT: This step is to be completed when the collar
is NOT on your dog.
• Remove two screws securing the battery compartment using
a cross head or Phillips head screwdriver. (fig. 1)
• Lift battery compartment from main body of Receiver Collar.
(fig. 2)
• Insert two CR2032 Lithium coin batteries into battery
compartment. Batteries should be placed with the positive
side facing down.
IMPORTANT: Follow orientation as described on graphics
illustrated on battery compartment. (fig. 3)
• Replace battery compartment with two CR2032 Lithium coin
batteries back into main body. Note: The battery compartment
can only be assembled in one orientation, do not force closed.
See markings on the battery door.
• Tighten the two screws using the cross-head screwdriver, do not
over tighten.
• To test the unit turn on by pressing and holding the control
button for 4 seconds. You will hear one long beep followed by
a sequence of short beeps and flashing green LED indicating
which correction level is in use. The Receiver Collar will recall the
last setting or the default setting (level 1 or low).
• To turn off the unit, press and hold the control button for
4 seconds. You will hear short beeps indicating the current
correction level followed by a long beep indicating the unit is off.
• Before replacing batteries you must completely discharge the
Receiver Collar. Be sure the unit is in the OFF position and place
the metal portion of a plastic handle screwdriver across both
stainless steel probes for 5 seconds. Dispose of batteries per
local, state and national laws and regulations.
figure 1
figure 2
figure 3