5
4
Always disconnect the kettle from the power
outlet before cleaning.
Never immerse the kettle switch area, cord or
power base in water, or allow moisture to
come into contact with these parts.
Descale Your Kettle Regularly.
Mineral deposits in tap water solidify when
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible. Phosphate scale isn't generally visible
however it may cause the water to appear
cloudy when heated. This may cause the
interior of the water gauge to discolour, cause
overheating, trigger the boil-dry cut-out
mechanism or even reduce the kettle’s life.
Even in soft water areas it is important to
descale your kettle regularly to help maintain
its lifecycle.
NOTE:
Failure to descale products regularly
can be deemed as negligent handling and
any faults caused by mineral build up will
not be covered by the Sunbeam 12 Month
Guarantee.
To remove this build-up, use Sunbeam Liquid
Descaler, a simple to use, non-toxic cleaner
available from electrical appliance specialists
and Sunbeam Appointed Service Agents.
Alternatively:
1. Fill the kettle with 1 cup of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2. Empty the solution from the kettle. Any
stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill
the kettle with clean water, bring to boil
and then discard the water. Repeat and the
kettle will then be ready to use.
CAUTION:
To prevent damage to the
appliance, do not use alkaline, chemical ,
steelwool or abrasive cleaners. Use a soft
cloth and a mild detergent to protect the
exterior surface.
To clean the filter.
Grasp the top of the filter and pull upwards
to remove. Wash in warm soapy water and dry
thoroughly before replacing
in the kettle.
Care and Cleaning
QUANTUM PLUS
KETTLE
®
User Guide
Need help with your appliance?
Contact our customer service team
or visit our website for information
and tips on getting the most from
your appliance.
Australia
|
visit
www.sunbeam.com.au
phone
1300 881 861
New Zealand
|
visit
www.sunbeam.co.nz
phone
0800 786 232
Newell Australia Pty Ltd. ABN 68 075 071 233
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2020.
GCDS-SUN1964178-LD
Part Number: 4176A / NWL0001318500 SAP:
KE2360
Australia
www.sunbeam.com.au
1300 881 861
New Zealand
www.sunbeam.co.nz
0800 786 232
KE2360
To assist us in managing warranty claims,
we recommend you register your product as
soon as practicable after purchase, on our
Sunbeam website and uploading a copy of
your original receipt. View the Support
section of the Sunbeam website.
