8
sPeciAl oPerAtinG notes
SLEEP MODE:
This is the normal operating mode of the bark control collar. The system has
been designed to maximize battery life. You can verify the status of the system by pressing
and holding the Main Control Button for 2 seconds.
The Sunbeam® Mini Bark Control Collar retains the LAST correction level setting and will
resume this mode when the unit is turned on.
The LED light will illuminate gREEN when a bark has been detected and a correction is
being administered.
OvER CORRECTION MODE:
As a safety feature, if excessive barking is detected the bark
control system will enter a mode designed to shut down the system.
The LED light will flash RED every 3 seconds for 2 minutes and will automatically reset. You
can manually reset the system by pressing and hold the Main Control Button.
LOW BATTERY MODE:
The LED light will flash RED for 5 seconds when the battery needs
to be replaced.
trAininG Guide
Proper training is essential to achieving the best results from the Sunbeam® Mini Bark
Control Collar for you and your dog. When first starting to use the bark control collar, you
should closely monitor your dog’s reaction when barking behavior is exhibited.
When you begin using the bark control collar, your dog should be inside a protected area.
The protected area should not be a cage, crate, or kennel. If outside, your dog should be in a
safe protected area so that your dog is unable to run away when they receive the correction
from the bark control collar.
Each dog can have a different reaction from the bark control collar’s correction. These
reactions can vary from a dip of the head, to shaking the head, whining, excessive barking,
confusion, or running away. In the event of an extreme reaction, wait until your dog is calm
before approaching your dog.
The reaction your dog will have is dependent on your dog’s personality. The first several
times you use the bark control collar, you must be present.