Heading
PROBLEM
POSSIBLE CAUSE
WHAT TO DO
The coffee brewing unit has
Ensure that when the hopper is
not adjusted correctly and
moved to the pre-ground coffee
remains closed, therefore the
position that prior to adding the
coffee falls beside.
coffee you have waited for
the programmed mechanical
adjustment of the brewing unit.
The pre-ground coffee is stuck After the machine has been used
to the sides of the coffee shaft. the steam from the brewing
process will moisten the sides of
the pre-ground coffee shaft which
causes the coffee grinds to stick
to the sides. Use a piece of paper
towel or cloth to dry the pre-ground
coffee receptacle and shaft.
Alternatively use the cleaning brush
to push down the coffee.
No espresso/coffee
No water in the water reservoir. Fill the reservoir with water.
pours through
The water reservoir is not
Slide the water reservoir in and
correctly engaged.
press firmly into place to ensure
the valve of the water reservoir
opens.
The steam pre-selection button Press the steam pre-selection
is activated.
button to turn the steam function
off.
Espresso/coffee tastes Temperature of the heating
Prior to starting the espresso
burnt
system is too hot.
brewing process, turn the steam/
hot water switch up and allow hot
water to run through the steam
arm/wand until there is a steady
flow of hot water and no large
amount of steam is present.
Type of coffee being used.
Experiment with different brands
and styles of coffee.
No steam comes
Steam arm/wand is blocked.
Using a pin or a thin wire, insert it
from the steam
into the hole in the base of the
arm/wand
steam nozzle.
Not enough froth when Milk is too warm or too old.
Ensure the milk is well refrigerated
texturing the milk
before use and that the milk is
fresh.
Trouble Shooting Guide continued
43
Summary of Contents for Intuitive EM8910
Page 2: ......
Page 37: ...35 Cleaning the coffee brewing unit continued Figure 54 Figure 57 Figure 55 Figure 56 1 2 3 ...
Page 49: ...Notes ...
Page 50: ...Notes ...
