13
Before using your Sunbeam Café Espresso
®
II for the first time or if you have not used it
for some time, rinse the machine by running
water through without coffee in the group
handle, as follows:
Note:
Throughout these instructions the
numbers you see highlighted and in brackets
refer back to the diagrams at the start of this
instruction manual.
• Open the lid of the water reservoir
(1)
and
fill with cold water
(2)
. Alternatively you
can open the lid and remove the water
reservoir using both hands
(3)
. Then fill
with cold water
(4)
.
• Replace the water reservoir firmly into the
unit
(5)
and close lid.
• Insert the power plug into a 230-240V AC
power outlet and turn the power ( ) on.
Start the unit
(6)
. The red power ( ) light
will illuminate and flash to indicate it is
warming up.
• Place one of the filters in the group handle
(7)
. Then position the group handle on the
machines brewing head
(8)
.
• To ensure that the group handle is in
the correct position, turn the handle so
it points to the left and place the group
handle flat against the brewing head
(8)
,
then turn the handle towards the right
(9)
,
as far as it can go.
Note:
Do not over tighten.
• Place a sufficiently large container under
the group handle pouring spouts
(10)
.
• When the power button has stopped
flashing and is completely illuminated, the
machine is ready for the next step.
• Turn the dial to the espresso (
)
setting
(11)
and allow all the water in the water
reservoir to run through.
• If necessary, you may need to stop the
operation by turning the dial to the off
( ) position, empty the container, then
resume the operation.
Note:
Make sure that the water reservoir is
clean and free of any debris, as any fine
particles can block the water flow.
Before using your Café Espresso
®
II
