![background image](http://html1.mh-extra.com/html/sunbeam/9103-9294/9103-9294_assembly-instructions-manual_1394597018.webp)
Care & Maintenance
you perform the following maintenance activities
on a regular basis:
Keep exterior surfaces clean.
or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around
the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use it. It must be replaced.
•
Keep the ventilation opening of the cylinder enclosure free and clear from debris.
include:
•
Fire table does NOT reach the desired temperature.
•
Fire table glow is excessively uneven.
•
Fire table makes popping noises.
use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
Note:
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
Storage
Between uses:
•
Turn Control Knob OFF.
•
Disconnect LP source.
•
protect exterior surfaces.
Note:
During periods of extended inactivity or when transporting:
•
Turn Control Knob OFF.
•
Disconnect LP source and move to a secure, well-ventilated location outdoors.
•
protect exterior surfaces.
•
Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note:
Service
Troubleshooting
WARNING
FOR YOUR SAFETY
minutes after use.
Fire table is hot to the touch.
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Burner won’t light
Propane cylinder is empty
Replace propane cylinder
Clear blockage
Control knob is not in ON position
Turn control knob to ON
Gas pressure is low
Outdoor temperature is less than 40°F
Use a full cylinder
Control knob is fully on
Carbon build-up
Clean burner
Thick black smoke
Blockage in burner
Remove blockage and clean burner inside & outside
1-877-387-3639 | Page 18