strona: 10 / 14
3.8.4. Marking and fixing the pergola awning frame.
Note
The main task of the pergola awning EVO is the protection from sunlight. There is also
the possibility of extra protection from the rain. The effectiveness of the removal of
water depends on the awning fabric, the width of the awning, and its angle of
inclination. The complete removal of the water carried with the use of the cloth is
reinforced by the sheet up to 3 m, and the width and with a minimum angle of 14°.
In any other case, you have to check the accumulation of water on the surface of the
awning, because it can damage the awning and also pose a danger to people.
Minimum inclination angle of the pergola awning EVO is 4°.
●
Square tube
(B)
to the shaft tube
(D)
and the front profile
(E)
push in the console
(A)
. Screws
(C)
tighten.
●
Mark and drill holes for the lower brackets
(F)
.
●
Check ground level.
●
In case the level difference between the lower brackets, you have to compensate for this difference
in levels by shortening of one vertical side profile
(G)
.
●
Transverse profil
(H)
with corner brackets
(J)
on the vertical side profiles
(G)
screws. Mounting cubes
of the brackets
(J)
in the channel of the profile
(G)
slightly stuck and then temporarily tighten the cap screw
on the profile
(G)
.
●
Put vertical side profiles
(G)
with corners and transverse profile
(H)
and lower brackets
(F)
to the
prepared holes and fixed to the ground.
●
Holding the frame as above, put the mounting of the horizontal side profil
(K)
in the mounting plate,
tighten screws
(M)
, and then the horizontal side profil
(X)
with the screws
(N)
on both sides of the pergola
awning at a distance of 130 mm screw from the end of the profile (in the standard version).
See the figure below:
●
Check parallelism of the horizontal side profiles
(X)
by the equality diagonal. Tighten the screws on
the vertical side profile in such a position that the profile
(X)
as close as possible to the vertical side profil
(G)
●
Tighten all screws.
