Chapter 7
Configuring VLANs
41
▼
To Configure VLANs in a Microsoft Windows
2003 Environment
1. Click Control Panel.
2. Click Network Connection.
3. Click the folder icon from the sub-manual bar.
4. Right-click the Sun 10GbE XFP SR PCI Express Card port, then select
Properties.
5. Click Configure.
6. Click VLAN, then click on New.
7. Type
VLAN
with
ID
(for example, type
Vlan10
).
8. Click Internet Protocol (TCP/IP).
9. Click Use the following IP address.
10. Type the IP address.
11. Click Subnet Mask.
The value
255.255.255.0
is displayed.
12. Click OK.
13. Repeat
through
until all the network ports are VLAN configured.
Note –
Ensure that the firewall is configured to allow VLAN traffic. Otherwise, the
VLAN might not operate properly.
Summary of Contents for Sun Dual 10GbE SFP+ PCIe ExpressModule
