Sun Microsystems Sun Netra CP3240, Installation Manual, Page: 97 / 131

Chapter 4 Configuring Switch Software 4-19
4.10.2 Basic CLI Commands
TABLE 4-6
Basic CLI Commands
Command Function Mode
enable
Switch to privilege mode. You must be in enabled
mode for most options. default
show port all
Show status of the ports. privilege
show interface ethernet 0/x
Show detailed statistics on port 0/x. privilege
clear counters
Clear all statistics. privilege
clear config
Restore the default configuration. privilege
show running-config
Show the current configuration of the switch.
This command shows everything that is not set to
the default value. The output is a script that can
be copied to a file for later use, or for another
switch. privilege
copy system:running-config
nvram:startup-config
Save the current configuration though a reboot. privilege
serviceport protocol dhcp
Use DHCP on the out-of band port. Only one of
the serviceport and network can use DHCP. To
enable DHCP on one, you must disable it on the
other. The same command works for network. privilege
serviceport protocol none
Use user assigned IP NOTE: the same command
works for network. privilege
serviceport ip <ip> <netmask>
<gateway>
Force an IP for serviceport. privilege
network parms <ip> <netmask>
<gateway>
Force an IP for network. privilege
show network
View the in-band management settings. privilege
show serviceport
View the out-of-band management settings. privilege
serial baudrate
Change the serial baudrate. privilege
vlan database
Switch to vlan database mode. Create and delete
VLANs here. privilege
vlan x
Create a VLAN with number x. vlan
exit
Return to one mode higher.
configure
Switch to configure mode. You must be in
configure mode to change most settings. privilege