Sun Microsystems Sun Enterprise 220R, Owner'S Manual

Page: 51 / 208

Chapter 2 System Setup 23
How to Place the System Into the Rack
This procedure assumes that the slide assembly is already installed in the rack. For
additional information on the slide assemblies and rack enclosers, see the setup
guide and the owner’s guide.
Caution –
The chassis is heavy, and two people are required to place the system
into the rack slide assembly in the following procedure.
Before You Begin
Complete the following tasks:
■
Identify a helper to assist you in removing the system.
■
Verify that your helper can safely lift and carry 34 lbs (17kg), which is
approximately half the weight of a fully-equipped system.
■
Assemble the correct tools for the procedure. See “Tools Required for Setup and
Rackmounting” on page 12.
■
Open (and remove) the rack enclosure front door.
■
Slide each rack assembly’s inner slide back into its assembly until the slide comes
to a complete stop against the interior glide tab.
Caution – When completing a two-person procedure, always communicate your
intentions clearly before, during, and after each step to minimize confusion.