Sun Microsystems StorageTek 6140, Manual

Page: 17 / 32

Install the storage array.
For instructions, see the StorageTek documentation listed in “Related Documentation” on page 6 .
Power on the storage array and the nodes.
For instructions, see the StorageTek documentation listed in “Related Documentation” on page 6 .
Configure the service processor.
For instructions, see the StorageTek documentation listed in “Related Documentation” on page 6 .
■
To create a logical volume, see “How to Create a Logical Volume” on page 17 .
■ If you added a new node, perform the steps in “Install the Solaris Operating System and
Configure Multipathing” on page 15 as appropriate. Apply the correct patches for storage array
support enable multipathing.
Configuring Storage Arrays
This section contains the procedures about how to configure a storage array in a running cluster.
Table 2–2 lists these procedures.
TABLE 2–2
Task Map: Configuring a Storage Array
Task Information
Create a logical volume. “How to Create a Logical Volume” on page
17
Remove a logical volume. “How to Remove a Logical Volume”
on page 19
The following is a list of administrative tasks that require no cluster-specific procedures. See the
storage array’s online help for the following procedures.
■
Creating a storage pool
■
Removing a storage pool
■
Creating a volume group
■ Removing a volume group
■ Creating an initiator group
■ Adding an initiator group
■ Removing an initiator group
▼
How to Create a Logical Volume
Use this procedure to create a logical volume from unassigned storage capacity.
4
5
6
See Also
Configuring Storage Arrays
Chapter 2 • Installing and Configuring a StorageTek Array 17