Sun Microsystems Netra T4 AC100, Service And System Reference Manual

Page: 233 / 284

E-1
A P P E N D I X
E
Example POST Diagnostic Output
This appendix provides examples of the POST output to serial port A. If POST fails
to complete, compare the last message output with the example. The next line in the
example may help to identify the cause of the problem.
CODE EXAMPLE E-1
is a typical POST output for a system with two 750 MHz CPUs
and 4 GByte of memory, and with the
diag-level
variable set to
max
.
CODE EXAMPLE E-1
diag-level
Variable Set to
max
(1 of 17)
@(#)OBP 4.2.3 2001/04/23 17:48 Sun Netra T4
Clearing TLBs Done
Power-On Reset
Executing Power On SelfTest
{0}
{0}@(#)POST, v4.1.7 01/22/2001 06:55 PM
{1}Transfered from OBP or Unknown source of reset
{0}PLL reset
{0}* Configure I2C controller 0
{0}* Configure I2C controller 1
{0}* I2C Controller Loopback Test
{0}* Read JTag IDs of all ASICs
{0} BBCJTag ID: 1483203b
{0} SCSIJTag ID: 15060045
{0} I chipJTag ID: d1e203b
{0} RIOJTag ID: 13e5d03b
{0} SchizoJTag ID: 1824c06d
{0} CPMSJTag ID: 1142903b
{0} CPMSJTag ID: 1142903b
{0} CPMSJTag ID: 1142903b
{0} CPMSJTag ID: 1142903b
{0} CPMSJTag ID: 1142903b
{0} CPMSJTag ID: 1142903b